The Brightest Way to Save!

PowerLux® is a registered trademark of PowerLux® Corporation

 

Home

PowerRim
- Why it works
-
Installation
-
Advantages

Your Savings

Case Histories

Ordering/Technical Information

Contact Us

 

 

Case History 1: Carlsbad Seapointe Resort (Carlsbad, CA)

Area:

Clubhouse, kitchen and food preparation areas (newly constructed)

Ceiling height:

~20 ft.  Previously used halogen PAR lamp 120W for the recessed downlights

Problem:

Not bright enough and it was very difficult to frequently change burnt out bulbs.

Solution:

PowerRim™ 42Ws (equivalent to 200W incandescent  light output) were selected after on site testing and approval by the owners’ association.

Savings after conversion to PowerRim:

64% reduction in energy consumption with a much higher lighting level!

Case History 2: University of California, San Diego, Medical School

Area:

Elevator lobbies and public areas in Medical Teaching building.

Ceiling height:

~10 feet  Previously used  75W incandescent reflector lamps.  Tried many different types and brands of disposable CFLs in the recessed downlights without success.

Problem:

Too little light and lamps did not last 10,000 hours as advertised.  Frequent re-lamping due to early failures of the disposable CFLs.   Areas were dark and dingy.

Solution:

PowerRim™ 18W (equivalent to 75W incandescent light output) were installed and was commented as being “too bright”, so, UCSD maintenance staff capped-off every other lighting fixture and used only half the number of downlights.

Savings after conversion to PowerRim:

88% reduction in energy consumption with improved, evenly diffused lighting.

Case History 3: Coronado Springs Resort & Convention Center,
Walt Disney World (Orlando, FL)

Area:

2,000 guest bathrooms in this hotel and convention complex.

Ceiling height:

~ 8 ft.   Bathrooms were too dimly lit.

Problem:

Tried all the other solutions and disposable CFLs.  Even installed new fixtures but light output was still weak and could not penetrate to the shower stall area of the bathrooms.  Fixture could not accommodate higher wattage incandescent lamp due to overheating and triggering of the thermal safety switch inside the recessed can.  Electricity costs were not a main issue as Disney generates its own at 3 cents KWH.

Solution:

PowerRim™ 26W (equivalent to 100W incandescent light output) was chosen after testing and comparing with all potential solutions. The bathrooms are now much brighter and the light penetrated behind the shower curtain, providing more and better lighting for the guests.

Savings after conversion to PowerRim:

PowerRim™ was considered an UPGRADE for the bathroom and resulted in a 74% reduction in energy consumption from previous lighting.